TSX-V: MKO; OTCQX: MAKOF
VANCOUVER, BC, July 20, 2020 /CNW/ - Mako Mining
Corp. (TSX-V: MKO) (OTCQX: MAKOF) ("Mako" or the
"Company") is pleased to report positive results from definition
drilling around the West Pit area at its wholly owned San Albino
gold project ("San Albino") located in Nueva Segovia, Nicaragua.
The objectives of the definition drilling at San Albino were to
delineate the geometry of the mineral resources amenable to open
pit mining and to provide sufficient information for a new mineral
resource estimate currently being prepared by Mine Development
Associates ("MDA"), a division of RESPEC Company LLC.
A total of four holes disclosed in this press release (SA20-503,
SA20-506, SA20-490 and SA20-498) had significant intercepts outside
of the previously defined pit limits that supply the mill feed for
open pit mining disclosed in the Company's Preliminary Economic
Assessment for the San Albino Gold Deposit dated April 29, 2015 (the "PEA"), which is available on
the Mako's website and SEDAR profile at www.sedar.com (see attached
map and cross section).
The highlight of this press release is drill hole SA20-503,
which intersected 21.61 g/t Au and 41.9 g/t Ag over 5.0 meters
("m") (4.5 m estimated true width)
approximately 64 m below surface and
approximately 4 m below the West Pit
limit disclosed in the PEA.
SA20-506 intersected 5.37 g/t Au and 20.3 g/t Ag over
4.3 m (2.74
m true width) 85 m below
surface and 34.4 m below the West Pit
limit in the PEA.
SA20-490 and SA20-498 were designed to test an extension of the
San Albino Zone to the southwest. SA20-490 intersected 20.40
g/t Au and 49.3 g/t Ag over 1.25 m
(1.03 m estimated true width)
28.4 m from surface and approximately
100 m southwest of the West Pit limit
disclosed in the PEA.
SA20-498 intersected 9.79 g/t Au and 31.3 g/t Ag over
3.3 m (1.84
m estimated true width) 42 m
below surface and approximately 80 m
southwest of the West Pit limit disclosed in the PEA.
Also noteworthy were holes SA20-457, SA20-504, SA20-507 and
SA20-509, which provide evidence of continuity of an upthrown block
across a fault that brings the San Albino Zone 20 m closer to surface than the previous down dip
projections (see attached map and cross section). The
highlight was SA20-457, which intersected 27.70 g/t Au and 26.2 g/t
Ag over 3.1 m (1.98 m estimated true width) 32 m below surface.
Akiba Leisman, Chief Executive
Officer of Mako states, "although the assays from these holes came
back after the original cutoff date for preparing the updated
mineral resource estimate, the Company and MDA concluded that they
are significant and should be included in the updated mineral
resources estimate. Importantly, the updated resource
estimate is still on track to be delivered this quarter."
Assay Results Reported In This Press Release
Drill
Hole
|
From
(m)
|
To
(m)
|
Width
(m) *
|
Au
(g/t)
|
Ag
(g/t)
|
Interval
Averages
|
True Width
(m) **
|
SA19-371 to
373
|
|
|
|
|
|
No significant
results;
targeting Naranjo
Zone
|
|
SA20-453
|
20.70
|
25.50
|
4.80
|
|
|
Void
|
|
SA20-457
|
46.80
|
47.80
|
1.00
|
1.41
|
10.6
|
27.70 g/t Au and 26.2
g/t Ag over 3.1 m
|
1.98
|
47.80
|
48.85
|
1.05
|
7.20
|
12.9
|
48.85
|
49.90
|
1.05
|
73.30
|
54.3
|
SA20-465
|
|
|
|
|
|
No significant
results
|
|
SA20-490
|
28.4
|
29.65
|
1.25
|
20.40
|
49.3
|
20.40 g/t Au and 49.3
g/t Ag over 1.25 m
|
1.03
|
SA20-498
|
54.50
|
55.80
|
1.30
|
8.88
|
27.4
|
9.79 g/t Au and 31.3
g/t Ag over 3.3 m
|
1.84
|
55.80
|
56.80
|
1.00
|
16.10
|
47.1
|
56.80
|
57.80
|
1.00
|
4.68
|
20.5
|
SA20-502***
|
48.20
|
48.85
|
0.65
|
6.96
|
10.5
|
4.69 g/t Au and 7.3
g/t Ag over 2.8 m
|
1.80
|
48.85
|
49.65
|
0.80
|
0.16
|
0.7
|
49.65
|
50.50
|
0.85
|
5.04
|
9.8
|
50.50
|
51.00
|
0.50
|
8.39
|
9.5
|
SA20-503***
|
57.90
|
58.80
|
0.90
|
10.50
|
93.0
|
21.61 g/t Au and 41.9
g/t Ag over 5.0 m
|
4.50
|
58.80
|
59.95
|
1.15
|
0.04
|
0.5
|
59.95
|
61.05
|
1.10
|
73.30
|
88.0
|
61.05
|
62.05
|
1.00
|
16.70
|
27.0
|
62.05
|
62.90
|
0.85
|
1.46
|
1.4
|
SA20-504
|
44.10
|
44.80
|
0.70
|
2.43
|
4.5
|
2.43 g/t Au and 4.5
g/t Ag over 0.7 m
|
0.61
|
46.10
|
46.60
|
0.50
|
7.28
|
29.0
|
7.28 g/t Au and 29.0
g/t Ag over 0.5 m
|
0.45
|
SA20-506
|
75.40
|
76.40
|
1.00
|
15.90
|
64.9
|
5.37 g/t Au and 20.3
g/t Ag over 4.3m
|
2.74
|
76.40
|
77.50
|
1.10
|
5.32
|
17.4
|
77.50
|
78.70
|
1.20
|
0.25
|
1.4
|
78.70
|
79.70
|
1.00
|
1.04
|
1.5
|
SA20-507
|
30.60
|
31.60
|
1.00
|
16.70
|
29.9
|
18.16 g/t Au and 25.6
g/t Ag over 2.2 m
|
1.91
|
31.60
|
32.25
|
0.65
|
19.70
|
13.0
|
32.25
|
32.80
|
0.55
|
19.00
|
32.7
|
SA20-509
|
31.20
|
32.20
|
1.00
|
6.34
|
9.9
|
6.34 g/t Au and 9.9
g/t Ag over 1.0 m
|
0.90
|
The mineralized intervals shown above utilize a 1.0 g/t gold
cut-off grade with not more than 1.0 meter of internal dilution.
*Widths are reported as drill core lengths. ** True width is
estimated from interpreted sections. *** Holes SA20-502 and
SA20-503 include up to 1.2 m of
internal dilution.
Sampling, Assaying, QA/QC and Data Verification
Drill core was continuously sampled from inception to
termination of the mapped mineralized interval. Sample
intervals were typically one meter. Drill core diameter was
HQ (6.35 centimeters). Geologic and geotechnical data was
captured into a digital database, core was photographed, then
one-half split of the core was collected for analysis and one-half
was retained in the core library. Samples were kept in a
secured logging and storage facility until such time that they were
delivered to the Managua
facilities of Bureau Veritas and pulps were sent to the Bureau
Veritas laboratory in Vancouver
for analysis. Gold was analyzed by standard fire assay
fusion, 30gram aliquot, AAS finish. Samples returning over
10.0 g/t gold are analyzed utilizing standard Fire
Assay-Gravimetric method. The Company follows
industry standards in its QA&QC procedures. Control samples
consisting of duplicates, standards, and blanks were inserted into
the sample stream at a ratio of 1 control sample per every 10
samples. Analytical results of control samples confirmed
reliability of the assay data.
Qualified Person
John M. Kowalchuk, P.Geo, a
geologist and qualified person (as defined under NI 43-101) has
read and approved the technical information contained in this press
release. Mr. Kowalchuk is a senior geologist and a consultant to
the Company.
On behalf of the Board,
Akiba
Leisman
CEO
About Mako
Mako Mining Corp. is a publicly listed gold mining, development
and exploration company. The Company is developing its high-grade
San Albino gold project in Nueva
Segovia, Nicaragua. Mako's
primary objective is to bring San Albino into production quickly
and efficiently, while continuing exploration of prospective
targets in Nicaragua.
Forward-Looking Statements:
Statements contained herein, other than of
historical fact, may be considered "forward-looking information"
within the meaning of applicable securities laws. Forward-looking
information is based on certain expectations and assumptions,
including the Company's expectation that it will bring the San
Albino into production quickly and efficiently, while continuing
exploration of prospectus targets in Nicaragua; that the Company's exploration and
in-fill drilling programs will be successfully completed; that any
outstanding assay results will be as anticipated; that there is
continuity of gold mineralization outside of the originally defined
pit limits for San Albino; that the objectives of the
definition drilling at San Albino, to delineate the geometry of the
mineral resources amenable to open pit mining and to provide
sufficient information for a new mineral resource estimate, will be
achieved; that the Company will be able to successfully adjust its
mine plan based on anticipated successful drilling results; that
the geological model will continue to yield highly predicable
results; that although the Company's production decision at its San
Albino project is not based on a technical study supporting mineral
reserves, and therefore not based on demonstrated economic
viability, management expects economic viable production; that the
Company will be successful in completing its mine construction at
the San Albino project. and such other risk factors as outlined in
the continuous disclosure documents of the Company filed on SEDAR
at www.sedar.com. Such forward-looking information is subject
to a variety of risks and uncertainties which could cause actual
events or results to differ materially from those reflected in the
forward-looking information, including, without limitation, the
risks that additional satisfactory exploration and drilling results
at San Albino will not be obtained; that the PEA is preliminary in
nature and there is no certainty that the PEA will be realized; the
risk of economic and/or technical failure at the San Albino project
associated with basing a production decision on the PEA without
demonstrated economic and technical viability; that exploration
results will not translate into the discovery of an economically
viable deposit; risks and uncertainties relating to political risks
involving the Company's exploration and development of mineral
properties interests; the inherent uncertainty of cost estimates
and the potential for unexpected costs and expense; commodity price
fluctuations, the inability or failure to obtain adequate financing
on a timely basis and other risks and uncertainties. Such
information contained herein represents management's best judgment
as of the date hereof, based on information currently available and
is included for the purposes of providing investors with the
Company's plans and expectations at its San Albino project and may
not be appropriate for other purposes. Mako does not
undertake to update any forward-looking information, except in
accordance with applicable securities laws.
Neither the TSX Venture Exchange nor its Regulation Services
Provider (as that term is defined in the policies of the TSX
Venture Exchange) accepts responsibility for the adequacy or
accuracy of this release.
SOURCE Mako Mining Corp.